Popular Racing Posts from the Past
By Don Terrill - www.RacingSecrets.com
Quench "flame channels" in piston vs. head quench
Port Vanes?
HONING procedure
DYNO Tails
two ring piston experience?
Valve/Rocker/Pushrod Geometry
Area under the curve
Guys I need some advise on bearings
How to tell if headers are too small?
Discussion: "Porting by Numbers" Darin Morgan
Widmer Terms
Merged Carb Spacers
Before/After grooved head pictures
Combustion Flame Speed
Squish ratio?
vein on the shortside of intake ports
If you could do anything to a cyl head?
pre-ignition / detonation(post ignition)
what do you guys think of this?
what do you guys think of this? Part II
wondering if there is a minimum port velocity
Exhaust back pressure power loss?
Valve angles
"well kept porting secret"
Calculating IFR/air bleed size on a Holley (long)
>100%VE
Funky airfoil in this intake bowl
Wideband Tuning for Carbureted Drag Racing
Larry's Soft Head
I wish Engine Masters would post BSFC numbers too
Experience With "Balanced Cams?"
pump gas/low compression/ high hp
Importance of Valve Events
help with switching to 0-30w oil
Flowing ports.....maybe we have it all wrong
Crank Twist: How Much?
fps question......
Want to send off a nasty email about how wrong I am? Well, first read this and then write your own article.
